THIS  IS  A  SETUP,  I  TELL  YA!  IT'S  ALL  A  SETUP ...
Our basic test setup is simple, almost to the point of being crude, but with care we
can get the sample positioned and aligned in minutes. The small vise at the left 
supports the metal tube sample within the tailpipe of the DynaJet. At the far right,
note the glass jar 'fuel cell', the air hose connected to the 'flowjector' and the
high voltage leads still connected to the spark plug [energized only for starting].
The sample here is 1/2-inch [13mm] OD mild steel tubing, as described in the text, 
positioned only about an inch [25mm] inside the end of the pipe, in this case.
Photo by Larry Cottrill - Copyright 2003 Larry Cottrill